SKP-K Colloidal Silica for Faster Shell Building and Easier Knockout
WELL-T's SKP-K series is designed to help investment foundries shorten shell-building cycles while balancing shell strength with easier removal. Its modified particle structure supports slurry stability, faster drying, and improved shell breakdown after firing.
Designed Around the Shell-Building Process
The series combines silica surface functionalization with a polymer coating. This approach is designed to create connected pores that help moisture escape during drying and support a shell structure that can break down more readily after firing.
Performance Highlights
WELL-T's reported development tests and comparisons highlight the following results. The figures relate to the tested systems and should be validated under each foundry's own materials and operating conditions.
Shell strength: average wet strength of at least 6 MPa across three shell-building trials, representing an improvement of more than 60% against the conventional comparison used.
Shell removal: approximately 70% lower residual strength in the reported comparison, supporting easier breakdown after firing.
Drying and throughput: approximately 70% shorter drying time and a reported efficiency improvement of more than 40%. The total shell-building cycle was reduced from more than 72 hours to 40 hours or less.
Slurry stability: the tested slurry maintained a reported pH of 8.93 over 35 days, with controlled microbial growth. The source reports a substantially longer usable period than the conventional formulation.
Process simplicity: the series is intended for both prime and backup coats, offering a common approach to slurry preparation and simpler process management.
A Practical Option for Continuous Production
SKP-K gives foundries a route to evaluate faster shell building without treating shell removal as a separate problem. WELL-T can help customers match product selection and trial conditions to their existing process.